Since I appropriated the cabinet that was living under my slider for the sanding station I recently posted about, I needed a new and better way to store my table saw blades. Using the old adage, "to a hammer, everything is a nail", I decided to build a drawer based blade storage unit using my CNC and some 1/2" maple plywood I happened to have available. It was a good exercise in "quick design" and the machine actually had a nice advantage making the blade drawers as you'll see in the photos below. At any rate, It's not pretty; it's not entirely precise, but you know what? It does the job nicely and looks decent enough.
Design is approximately 14" wide by 17" deep by 10" tall and accommodates four 12" blades and four 10" or smaller blades. In retrospect, I should have just cut all of the drawers for 12" blades since that makes size the least common denominator. Maybe next time. LOL
IMG_3058.jpg IMG_3059.jpg IMG_3069.jpg