Upgraded from a porter Cable planer to a used DeWalt 735. Flipped the blades and replaced the broken drive belt. Overall it runs great and I get very little to no snipe. Problem is that when I run a wide board (11 inches or more) through it seems to slow down when it reaches the blades then the speed picks back up when it hits the second set of rollers. I have cleaned both indeed and outfeed rollers with mineral spirits several times. Even with the slow down it isn't causing any snipe to speak of. Could I have messed the blade alignment up when I changed the belt. It was a bear to get back on. Seems to slow down more on the right side. Any help is appreciated.