I was finally able to fire up my DC from Clear Vue yesterday. It has taken forever, but once I did, I found something that I did not expect. I have the cyclone dumping into a Brute plastic receptacle. My anticipation was that it would end up somewhat pressurized but instead after running for about 45 minutes, the sides were some what caved in, meaning that the can had a suction applied. Is that normal or did I mess up the install some how?
I was running a wide belt sander so everything I collected was saw dust, no shavings from a planer or jointer. I was also a little surprised by how much dust there was in the bottom of the filter case.