Hey guys I’ve got this build with arched double doors 40” tall.
Looked ok until I mounted the doors and one of them has a twist of about 1/4” (left door bottom center).
I know now it’s npbecause I forgot to check the doors after I clamped them up.
I can handle it with a latch or catch, but I’d like to get the twist out if I can.
I’ve checked the opening everything is good the problem is the upper rail/stile on the left side are not flat.
The panel is glued in so surgery is a bad option. I’ve thought about running a deep groove in both stiles and glueing in a spline, clamping to a flat surface.
Any suggestions?
AFE66D1C-3824-4BC9-B64A-1217968C785F.jpg