Quote Originally Posted by Girard Ibanez View Post
Tim, I recently put a down on a A3-31.

Question:

1) DRO preference imperial or metric, pros and cons. I normally use the Imperial system but conversion from one unit to another is a non issue.

2) What are the mobility kit wheel diameter size? My garage has a wide groove aka expansion joint in the concrete flooring. Will the mobility wheels easily roll over this groove without hassel.

2) Extension tables ... As a hobbyist, what size and where should I add the extension table (infeed / out feed). Not sure what size to purchase.
Hi, I'm not from Felder USA, I'm from Felder Canada.

As I indicated in your other thread, go metric.

As for table extensions on the A3, I use the part number 500-101 for planer out feed simply to keep short pieces from falling on the floor. This is the 150mm wide X 400mm long extension. You cannot mount a planer in feed extension.

I also have another 500-101 so I can add to the jointer in feed and out feed, and I have a 500-129 which is 800mm long, I mostly use that on the shaper, especially when doing insertion moulding.

Regards, Rod.