Hi all, i need some advice on flattening veneer that has lettering on one side. I know basically how to do it if it was plain veneer, but never tried doing it with writing. I restore ouija boards. The old wooden ones prior to the late 30’s. I have done many over the years but never had one like this. It has major water damage. The veneer on both sides became wavy and separated/cracked etc. some of the black ink used back then has run a bit onto the clean wood sections. Both front and back veneer are now free from the core piece of pine they used. Im guessing the veneer is also pine. Here is where i need the help. What is my best way to soften the veneer before pressure without damaging the ink letters more? Can i wet from the side without lettering? And also is there a way to remove or lighten the areas where the ink ran? Some spots i can see the black ink has soaked through the veneer completely. I wasnt sure if anyone had a trick for lightening/removing. Thanks for any help