Had a pile of cut-offs and the like, left over from the Microwave Cabinet build....resaw some into something I could make use of. Stuff too "knotty" was sent to the burn pile..the rest?
close the lid.jpg
Just a little box...just under12" long, counting the lid.
handle.jpg
Box ends are 6-1/2" wide. Raised panels are done with a hand plane. Small handle to dress things up a bit
foot pads.jpg
Steel toed feet? Panel is some left over 1/4" Luann plywood. Corner joints are just Tongue and Groove glue joints.
lid is on.jpg
Small, steel Stanley hinges....lid was a cut off, from the 1 x12 used in the Microwave Cabinet's topper.
Router was used to round over most of the edges.
Not a bad way to use up a pile of scraps?