Results 1 to 2 of 2

Thread: Connect AutoLaser software to X700 laser

  1. #1

    Connect AutoLaser software to X700 laser

    Greetings,

    I have a new X700 and am struggling to get the PC to talk to the laser. It connected somehow yesterday but today I cannot figure out how to get it to communicate again.

    At the bottom of the AutoLaser screen, it says "Connect the control card success!" so it apparently sees it at least.

    I have a Topwisdom controller.

    Any advice is appreciated.

    Gary

  2. #2
    Nevermind everybody. I figured out after a while. Documentation is a bit sketchy.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •