The last week or more I've been working on a simple cake topper.....Heart shape, two legs, with message. The problem is the legs. I process everything in Corel but when I import the file into RD Works it's "corrupted" somehow. First it's rotated about 2 degrees counter clockwise and the legs are obviously not the same..........I measured them with a caliper and they're both the same at the bottom with the R leg about .035 wider over 4.25" while the L side is about .050" narrower over the same length. I've printed from Corel and they're both the same. Until today I assumed the problem was on my end but I finally drew a rectangle the correct size in Corel, copy/paste, and modified the heart to accommodate them. I don't see where this is a Rabbit problem but I don't know exactly what to do next. Any suggestions will be appreciated.