Hi Julie, I didn't realize that the code was different for "manufactured homes"...............Regards, Rod.
You say gas for the dryer and the stove? If so just replace the outlets and install standard 120 outlets. Then replace the double breaker with a single 20 amp breaker. This assumes you have a separate ground wire to the outlets. Are the existing outlets three or four pole?
If you are keeping the electric dryer it is more complicated. If you have a duel fuel stove it gets tough as well.
“Travel is fatal to prejudice, bigotry, and narrow-mindedness..." - Mark Twain
I was waiting to be corrected on the ground-neutral thing
Assuming the existing outlet is a 4-wire unit like it should be for mobile homes, AND that the dryer will get its own breaker-
pwrd.jpg
-better? (had to add my own ground bus!)
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
That is a 220 line with a neutral designed for that application. You can not tap off a 220 line even with a neutral because that device will not be protected. The device could be a 220 20 amp with neutral circuit for the stove and the breaker is 220 20 amp breaker You add more to that circuit if you tap the line. Now that breaker is overloaded.
John T.
Mobile homes don't always meet the NEC, as they are a listed UL ASSEMBLY. This way, they don't have to be built to meet every different local set of codes. They have a title down at the DMV. Being a mobile home, you should have a four wire recpt for dryer, which would include two hot legs, a ground and a neutral. You would only need one of the hots, neutral and ground, plus change out breaker to be a single pole. Kev's drawing shows ground being used as a neutral, which is a big NO-NO!
no -
First drawing did, revised drawing above shows all grounds an neutrals separated--
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle