What do you use to round the edges of plywood drawers?
Jim
What do you use to round the edges of plywood drawers?
Jim
I never round plywood corners on any real work. I simply give it a quick swipe with a sanding block to ease the corner just enough to avoid splinters
Router with a 1/4" roundover bit.. If you have the drawer already put together then you can either make a fence for the router to do it hand held or run it uside down on the inside and outside using a router table with a bottom bearing roundover.
If I'm edge banding it, a 45* Chamfer bit just kissing the surface, and then sand them by hand. Otherwise I've done an 1/8" roundover bit.