Total length of 1x12 for small DTC

[Tony Wilkins]

Clamp a board across the width.

Heck, clamp the board flush with your baseline and you've done the 140 trick without the 140.

And word to the wise: mark your faces. Mark your faces. Mark your faces. And don't forget to mark your faces.

That’s a great idea. Now I just have to figure out what clamping type to use.

[steven c newman]

IMG_5051 (640x480).jpg
Just a thought.....
corner clamped.jpg

[David Eisenhauer]

Please, Tony, I'm begging on bended knees - mark the faces. Don't forget.

[David Myers]

That’s a great idea. Now I just have to figure out what clamping type to use.

A small quick release clamp would be fine. Ditto C clamps. If you decide to try the fake 140 way just make sure the clamp pad doesn't overhang toward the pin board side.

And if it's too cumbersome just move it back, line things up, and get 'em marked.

[Tony Wilkins]

Please, Tony, I'm begging on bended knees - mark the faces. Don't forget.

That was done before I did the tails.