I was cutting parts with my router the other day, my incra stop extension bar moved very slightly with every cut and result was that I had to redo four hours of work. When I realized this I was not thrilled, and removed the extension bar. It reminded me of how important a robust design is.

So, I’m happy to say that this stop does not move. I don’t slam work against a stop, but I think this could handle that without issue.



Unfortunately I need to redo the ends, I used an end mill to cut them to size, expecting to ream them slightly over size after that. Well the endmill cut it .005” oversized! I reamed them to the next size up then installed sleeves but I plan to redo it and change the design slightly as I do.

Once I get it right I plan to radius the end caps.