Results 1 to 4 of 4

Thread: HF Media Pot?

  1. #1
    Join Date
    Mar 2018
    Location
    Central PA
    Posts
    214

    HF Media Pot?

    I purchased the HF blast cabinet and two of the pressurized media pots. I'm pretty sure I read that the pots should be cleaned of any oil, etc before adding the media but I was unable to pull that up with a search. If this is in the wrong place please feel free to move and will appreciate any input! Everyone have a good day

  2. #2
    Join Date
    Aug 2006
    Location
    Suwanee, GA
    Posts
    3,601
    I have used several of the HF pots over the years and never cleaned a single one of them before using - they all seemed to work fine for me and I did A LOT of sand carving. The only modification I made to them was to extend the pickup tube inside so that it would be less likely to clog. Other than that, bought 'em, filled 'em, blasted stuff.
    I have done so much with so little for so long, that I can do almost anything with practically nothing...

    Trotec Speedy 400 80 watt 8/2015
    G. Weike LF-30, 30 watt galvo fiber - 1/2016
    G. Weike LF-30, 30 watt galvo fiber - 3/2015
    Fargo HDP5000 Card printer


  3. #3
    My experience was the same as Gary's.
    Mike Null

    St. Louis Laser, Inc.

    Trotec Speedy 300, 80 watt
    Woodworking shop CLTT and Laser Sublimation
    Evolis Card Printer
    CorelDraw X5

  4. #4
    Join Date
    Mar 2018
    Location
    Central PA
    Posts
    214
    Thanks guys!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •