My MFT sits behind my tablesaw in the space normally occupied by an outfeed table, but being about 3" lower than the saw table surface it isn't ideal as an outfeed table. Here's what I did.

I had this bank of rollers from a long time ago, but it needed a boost and a way to attach it to the MFT table in a removable manner. So I combined the roller bank, a wooden spacer and one of these stops from Lee Valley to bring the rollers to the right height.

I can position the rollers anywhere on the MFT depending on the length of material I am processing.

http://www.leevalley.com/us/wood/pag...37&cat=1,41637

IMG_0526.jpgIMG_0530.jpg