I've been trying to find some directions or vids on how to use the D4R Pro to do breadboard ends, but can find any. I know Leigh shows the breadboard ends, however there are no demos on how to. Anyone know of any?
I've been trying to find some directions or vids on how to use the D4R Pro to do breadboard ends, but can find any. I know Leigh shows the breadboard ends, however there are no demos on how to. Anyone know of any?
I am puzzled. How will a dovetail jig be used to make breadboard ends?
See this link. https://www.youtube.com/watch?v=8WhiY_2R-XM
I don't have bar shown in the video, but I could make one.
Last edited by lowell holmes; 09-18-2018 at 4:50 PM.
It is made with the breadboard vertical and the dove tail bit is centered on it instead of at the outer edges...
If you do not have the bar, you can make one out of any hardwood... not sure of size but if memory serves me it it 1/4 x 1/4
Ed, thanks. Kinda figured it was like that, however I wanted to see if there was simple way of centering the DT bit on the edge of the Breadboard end.