Page 2 of 2 FirstFirst 12
Results 16 to 18 of 18

Thread: Outfeed Table for DeWalt 7491RS Portable Saw Part 1

  1. #16
    Join Date
    Apr 2009
    Location
    Palm Springs, CA
    Posts
    1,085
    Quote Originally Posted by Christopher McKinney View Post
    Hi, just wondering, do you think the measurements would be pretty similar for a Dewalt 7480?
    I honestly don't know the answer to that. Perhaps a comparison check of the table sizes might be a good indicator?
    Dick Mahany.

  2. #17
    Join Date
    Sep 2020
    Location
    Oakland, CA
    Posts
    253
    How is that infeed take mounted? I have a similar outfeed table to the original posted I this thread, but I could really use an indeed table (who couldn't with these tiny saws).

    Of course, I have a sawstop coming in a month, so I just have to survive until then.

  3. #18
    Join Date
    Apr 2009
    Location
    Palm Springs, CA
    Posts
    1,085
    Quote Originally Posted by Aaron Liebling View Post
    How is that infeed take mounted? I have a similar outfeed table to the original posted I this thread, but I could really use an indeed table (who couldn't with these tiny saws).

    Of course, I have a sawstop coming in a month, so I just have to survive until then.
    The infeed table is in this thread https://sawmillcreek.org/showthread....DeWalt-7491-RS
    Dick Mahany.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •