I'm about to get the Leigh Upgrade Kit for my D4. I see that I must drill holes in the fingers of my jig, in order to insert the stop rod for single pass DTs. I'm wondering if anyone here has done that, how you did it and was it difficult? Thanks!
I'm about to get the Leigh Upgrade Kit for my D4. I see that I must drill holes in the fingers of my jig, in order to insert the stop rod for single pass DTs. I'm wondering if anyone here has done that, how you did it and was it difficult? Thanks!
I just bought a left and right finger with the holes pre drilled and set up the jigs shown on the Leigh site. A very easy process, and I'm not sure that the purchased ones were required for accuracy. Good luck to you!
If it's true that we are here to help others, then what exactly are the others here for?