Hello All
I have done a fair amount of reading about using an HVLPSpray Gun to apply Latex Paint. I know Latex is thick compared to top coats andother finishes. I have seen videos where people are using wiper fluid anddistilled water to thin Latex by about 20% and it would appear that they aregetting good results. My compressor puts out 6.8CFM and 40PSI which is enoughfor the gun that I am planning to purchase. The CFM requirement of the gun is 4.2 to 7.1 CFM. Here is a link to the gun:
https://www.amazon.com/dp/B001NOU92G/?coliid=I368QMCK8GD38G&colid=74OBKZYHBTAZ&psc=0&re f_=lv_ov_lig_dp_it
Based on posts in this forum, it looks like the minimum tipsize should be 2.0. I could also get a gun with a 2.5 Tip. Any thoughts onwhich tip size would be best?
Thanks, Bill