Hello All,
I am in progress of getting my production vac fixture designed and cut out. I plan to cut the prototype out of MDF and then switch to another " still undetermined " material for the final permanent fixture board. let me know your thoughts this board will hole (9) 11"x14" solid wood blanks to be machined 9 at a time. Let me know what you think good or bad. This is the only picture i have of this prototype at the moment due to my minimax sliding table saw attempting to catch fire on me while this was cutting so I was a little sidetracked during the initial cut. But this now has the center hole cut out and a gasket groove between the outer profile and the grid pattern and the grid has been machined down to .05 thickness to allow the outer edge to "capture the blanks" and assist with horizontal movement and the vacuum will cover the vertical movement. Let me know what you think. Thanks
IMG_2847.jpg