I just finished assembling a recent SawStop purchase, an ICS with a 5hp single phase motor. I was prepared to install 10/3 SOOW cable to the saw but the supplied strain relief on the SawStop terminal box is too small and the opening on the terminal box is sized for 1/2" conduit. SawStop technical support stated that 12/3 wire is OK. I looked inside the cabinet today and found all of the strain relief fittings to the motor and contactor box are the larger size for 3/4" conduit. I still think 10/3 cable is more appropriate for a 5hp motor and the strain relief fittings should be larger. Comments?