I bought a Axiom A/R 8 Basic last November and just getting to play with it. When I surfaced the spoil board had a heck of a time because of being out of the x & y soft limits. Which I figured out the problem there I was putting in the full size of s/b 48.5"x 24.5". So I change it to 48x24 and got it run that way but it left a 1/2" strip down left side and 3/4" strip on the bottom. I used a pocket path to do it first. Then tried a profile on the line pass with a 1.25 end mill was out of soft limits on x. So I tried profile inside the line it only cut .25 off the bottom and nothing off the side. Then I tried laying out a 1" grid down. I sent everything to the home then moved to origin and zero out, it went out touch cut about .5" in the y+ then picked up and y-. It tried to go beyond the end of the table started clicking. I'm using vcarve pro 9.
So any help will be much appreciated
Thank you
John