Page 2 of 2 FirstFirst 12
Results 16 to 19 of 19

Thread: Wiring up Powermatic 3520C - How to...

  1. 02-02-2019, 10:19 PM #16
    Sam Beagle
    Sam Beagle is offline Member
    Join Date
    Feb 2014
    Posts
    269
    I refinish wood floors for a living. And I use a buck booster for all my 208 jobs and I’ve monitored the voltage closely. Machine runs perfect.
    Reply With Quote Reply With Quote
  2. 02-19-2019, 1:26 PM #17
    Boyd Parks
    Boyd Parks is offline Member
    Join Date
    Sep 2018
    Posts
    2
    Just bought a new 3520C and it did have a cord, but no plug. I had already bought cord and a plug, so I didn't use it. I guess it was due to this thread I knew I needed it before I got the lathe. Thanks y'all!
    Last edited by Boyd Parks; 02-20-2019 at 8:19 AM.
    Reply With Quote Reply With Quote
  3. 07-23-2020, 12:06 AM #18
    David Walser
    David Walser is offline Contributor
    Join Date
    Dec 2006
    Location
    Mesa, Arizona
    Posts
    1,799

    Thank you!

    The information in this thread was very helpful.
    David Walser
    Mesa, Arizona
    Reply With Quote Reply With Quote
  4. 07-23-2020, 11:05 AM #19
    Reed Gray
    Reed Gray is offline Member
    Join Date
    Mar 2006
    Location
    Eugene, OR
    Posts
    5,700
    Not sure about all the electrical issues. However, it has been my experience at the convention centers, when turning on the lathes there, they seem underpowered, and it is supposedly due to the 208 or what ever volt 3 phase supply lines, which I think are aimed at commercial interests. Noticed this at several of the AAW shows, and at the Oregon Woodturning Symposium.

    robo hippy
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules