I have been using a 1" wide round head scraper for the insides of bowls but, on the inside of smaller bowls, the scraper is "grabbed" by the bowl.
Is the cause of this -
1. Whether the scraper is angled up, down, or level? OR
2. The scraper being too wide? Would a narrower scraper make this less likely?
3. Some other cause I just don't know about (since I haven't been turning that long)?
I am aware of negative rake scrapers and their potential advantages. For this post, though, I'm only interested in understanding why my round scraper catches lightly sometimes on the inside of small bowls. By small I mean 3" - 4" diameter bowls.