Not One, but I have TWO.... Walker Turner from the 1940s. One is earlier than the other one by a few years, one single phase 220 motor, the other one is three phase I run off of a VFD. Yes, Crosscut a LOT on both. 1x material, wide MDF (14") and other stuff as needed. Way easier than using my table saw and I don't have a miter saw. Craftsman I had, I loaned out never to see it again, and a cheap Lowes brand died and I never replaced with another. RAS way safer than those things anyway.
Woodworking, Old Tools and Shooting
Ray Fine RF-1390 Laser Ray Fine 20watt Fiber Laser
SFX 50 Watt Fiber Laser
PM2000, Delta BS, Delta sander, Powermatic 50 jointer,
Powermatic 100-12 planer, Rockwell 15-126 radial drill press
Rockwell 46-450 lathe, and 2 Walker Turner RA1100 radial saws
Jet JWS18, bandsaw Carbide Create CNC, RIA 22TCM 1911s and others