I’m helping someone with their shop setup. I’m having cabinets made with butcher block tops at the miter station area and would Ike to recess the Bosch 12” Glide. Planning for the cutout is tough though.
I measured the depth of the saw at 3.83” tall and I’d have the cutout at smidge more than that and shim the saw up as necessary.
For the awkward other measurements - Any suggestions on the approach? The width needed to miter is about 34”, so I suppose I’d have the cabinet maker make one cabinet that wide and make it shorter than the others?
How did you do your miter station?
Thanks