Page 2 of 2 FirstFirst 12
Results 16 to 20 of 20

Thread: Spindle adapter for threading jig

  1. #16
    Join Date
    Jan 2015
    Location
    Brentwood, TN
    Posts
    605

    Revised 3D design

    I've added the lock knob for the lateral slide, and hex bolts to be able to replace the side plates. I have about 50 5/16"-18 threaded inserts left over from a drawer handle project, so I can use them embedded in the horizontals.
    Attached Images Attached Images
    Maker of Fine Kindling, and small metal chips on the floor.
    Embellishments to the Stars - or wannabees.

  2. #17
    Join Date
    Dec 2005
    Location
    Suwanee (near Atlanta), GA
    Posts
    801
    Quote Originally Posted by Mark Greenbaum View Post
    I can purchase other 3/4" diameter thread rod configurations from McMaster Carr and get the hex nuts to fit. So it is adaptable. I'll see it I can make it work, then decide if I can afford to go further. The collet has been delayed 'til Monday.
    Mike Peace - your article and videos are really inspiring and if this works, all the better. If it doesn't, maybe post an addendum to your video and make a disclaimer?
    Thanks for your support. I don't have a video showing how to make a jig. I did post this video which one might consider a disclaimer https://www.youtube.com/watch?v=RIGS-fcl2LM
    God is great and life is good!

  3. #18
    Join Date
    Jan 2015
    Location
    Brentwood, TN
    Posts
    605
    Thanks Mike. I have been doing Honey-Do's all weekends, so progress has been slow. Almost there, though. I'll post pictures and maybe a video if I can get it to work like expected. It should do well for my amateur abilities.
    Maker of Fine Kindling, and small metal chips on the floor.
    Embellishments to the Stars - or wannabees.

  4. #19
    Join Date
    Nov 2006
    Location
    TX, NM or on the road
    Posts
    757
    A little late to the party on this one. But there is a guy on IAP that makes specialized tooling for penturners and one of the items is spindle adapters. http://www.penturners.org/forum/f349...ssories-92501/
    If he doesn't stock it, I bet he could make what you need.

  5. #20
    Join Date
    Jan 2015
    Location
    Brentwood, TN
    Posts
    605
    Quote Originally Posted by Marvin Hasenak View Post
    A little late to the party on this one. But there is a guy on IAP that makes specialized tooling for penturners and one of the items is spindle adapters. http://www.penturners.org/forum/f349...ssories-92501/
    If he doesn't stock it, I bet he could make what you need.
    Thanks, Marvin, but I had a Nova adapter for 5/8" diameter Shopsmith shaft remachined to fit inside the adapters for 1-1/4"-8 TPI at work. So I am goo now. Cut the side verticals tonight (measure twice, cut once, and still got it wrong - luckily too long). I'll drill all of the holes for spacer tubes and all thread rods tomorrow, and assemble by the weekend. Might have threads to take picture of by Sunday.
    Maker of Fine Kindling, and small metal chips on the floor.
    Embellishments to the Stars - or wannabees.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •