Been a long time since I have posted on here. I picked up a pristine Delta HomeCraft 28-110 10 inch bandsaw. I replaced the old tires with new urethane ones. The old 1/3 hp motor once I replaced the old paper capacitor runs like a chance. The first issue I had was the blade size. I ordered the appropriate size blade according to the manual, but I could not tension it because I ran out of room with the tracking screw slot. So I ordered a 70 1/2 inch blade which fit just fine. Here is my problem, the wheels are co-planer however, I cannot track the 3/16 inch blade without the upper wheel being extremely out of plane. The blade rides to the rear on the top wheel and toward the front on the bottom wheel. I have been using bandsaws for decades and have not run into this problem before. Are there any suggestions what could be the issue? As an added note, I've tried the 3/16 and 1/8 inch blades on this critter with the same issue.Band