Hey everyone,
So I have recently upgraded one of my lasers to a Laguna LCB Full Table Laser (60"x120") and I'm having some issues with the Y Axis.
What seems to be happening is when the laser is moving in the negative direction, and then quickly changing to the positive direction, the gantry starts to shake and give a very bad / rough cut until the machine stops shaking. I've worked with the company to get things as good as we can and it's still not even close to the quality of my other lasers.
I was wondering if anyone has any ideas on how to make this better or if there is a way to add a small delay before abruptly changing directions to avoid the shaking. If I run this machine at lower speeds it is better, but this plate is only being ran at 30mm/s which is about 1/20th of what the advertised speeds were.
I use RDWorks for running this laser and this does the same thing with many files created in various programs. This issues also only shows on curves and does not seem to be an issue when ran on straight lines.
IMG_2394.jpg
Thank you,
- Brandon