Metric units and formulas for machining?

[William Adams]

Does anyone have a link to or page with the metric versions of machinist formulas?

A link to an endmill manufacturer who lists their chip loads in a metric unit?

I know SFM become S.M.M. = Surface Meters per Minute and feed is usually in millimeters per min. MM.P.M. = Feed (travel in millimeters per Minute) --- found one page which lists F.P.T. = Feed per Tooth (in millimeters) --- is that equivalent to C.L.P.T. (chipload per tooth)

but not finding much else.

[Steve Middleton]

I'm pretty sure FPT and CLPT are the same. The numbers make sense.

[Mark Bolton]

Just about any of the downloadable chipload calculators will run either unit measure.