Get a foreman. Bee's knees.
Get a foreman. Bee's knees.
Wrong quote.
I am trying to figure out whether you use the top or side as the thickness of the piece you are drilling or does it matter. I think it is the top row. Anyone?
Thanks
George
Making sawdust regularly, occasionally a project is completed.
Thanks Mike.
George
Making sawdust regularly, occasionally a project is completed.
The dimensions that are listed vertically at the left side of the chart are the thickness of the piece being drilled.
Capture.JPG
Last edited by Lee Schierer; 04-15-2018 at 2:34 PM.
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute
- Although I have used eventually pocket hole in the past three decades, always they were made manually with no jig
- I am new to pocket hole jig but from all my researches, Kreg is the best one available in the market
- I went to K5 Master kit. It was very expensive in my country (around USD 300)... is that for the metric scale?
- It is a great kit but an overkill for an amateur using it occasionally
- Today if I had to decide again, I would go to Kreg, undoubtedly, but something more basic and cheaper.
Good luck in your decision.
All the best.
Last edited by Osvaldo Cristo; 04-15-2018 at 3:02 PM. Reason: better phrasing
There are only two variables with a Kreg jig, one is jig setting and one is screw length. A good way of understanding the jig is to remember that the jig setting is almost always intended to get the screw exit hole centered in the thickness of the workpiece you are drilling. The clue to what I am saying is found in the chart in that the jig setting almost always matches the column on the left. The only exceptions are in (rare) cases where the mating workpiece is substantially thinner in which case they recommend a lower jig setting to split the difference. Generally speaking, I always set the jig to the thickness of the material I'm drilling, and then pick the screw by the thickness of the mating piece. Hope this helps.
By the way, one great use of the Kreg jig is to use the pocket screws in places where they won't be seen as a means of clamping a joint. Let's say you have a long workpiece with dowels in the end, and no clamps long enough to clamp the joint. You can use a pocket screw for the sole purpose of pulling the joint together and acting like a clamp.
Oh, and if you want to plug the holes and don't care to spend the money on Kreg plugs, just buy 3/8" dowel rods from the home center and it should plug the standard sized Kreg holes perfectly. Just trim off with a flush trim saw.
Edwin
Last edited by Edwin Santos; 04-16-2018 at 10:06 AM.
There are basically two types of pocket holers. Those who bought a Kreg first, and those who wish they had.
We had an event to go to in Springfield Mo last weekend... so of course I HAD to go to the Grizzly Store. Wow !!!!
What a store. I and my wife were impressed. Great Store !!
And while we were there my wife bought me a Kreg K5 kit for my birthday