Hi

When I purchased my old Delta wood lathe it came with a number of tools and a few attachments. One of which was the very nice plexiglass shield and the wire guard. I've never used it and its been sitting in the corner of my basement since I go the lathe. I just always use a safety glasses or a full face shield when turning.

it has a bracket which was retrofitted on the lathe to hold it. If memory serves me right, its installation was an insurance company requirement for the woodshop it came from.

I'm wondering from the expertise in this forum the usefulness of this device.

Is this worth using for turning or perhaps selling or just an item for the junk collector?

thank you

'mark

shield_3.jpgshield_2.jpgshield_1.jpg