11/64” dia. Carbide halved round cutters.

[Phil Vernon]

Howdy,
I’m looking for a wholesale supplier of 11/64” diameter x 61/2” and 2” long carbide D-bit cutters.
Any recommendations.
TIA.
Phil.

[Chris J Anderson]

Hi Phil,
Talk to Cory at Rowmark Australia maybe ?

Cheers,
Chris

[Kev Williams]

Finding the cutters is easy. It's the "wholesale" part that's going to be your brick wall.

http://www.e-engraving.com/tools/index.htm << I found this page that lists tool mfr's. (note that "Antreas, Inc." is actually "Antares", and fwiw they're the only cutters I buy) - Good luck!

[Tony Lenkic]

Here is one link for a start.......
https://aes-group.com.au/categories/Engraving-Cutters/

[Phil Vernon]

Thanks for the recommendations.
AES is a pretty bog standard price very much in line with Gravograph and Trotec. I found a tooling specialist in Melb that will make them slightly cheaper but not really worth my while.
After working in that sector for the last 8 years I have a heap of customers asking me, as I still happily give advice on faults and the ‘ways of the engrave and cut’ :-)
so I was trying to source direct.

[Phil Vernon]

Hi Phil,
Talk to Cory at Rowmark Australia maybe ?

Cheers,
Chris

Yeah I might. Never worked with Corey he left Trotec before I started. I’m sharpening cutters for a few peeps and they are asking me for supply.
Have you tried the melt pass on the s/s? and I haven’t forgotten about the 500watt settings but been with Bodor up in the Country.....what an experience for them ‘the country’ and me ‘Them’ lol.