I've decided to make a treadle lathe. So far I have glued up and shaped the 24 inch flywheel. I wanted this to be done by hand so I cut and cut and cut some more with a hand saw. I finally felt confident enough to saw true and square. It took me a while to not go crooked or cut at an angle.

As you can probably tell, I have very little experience and would like some advice. The headstock is a part I want to do right the first time. I would like to be to be able to have options other than a piece of rolled steel sharpened to a point. What do you guys recommend? Im not sure if I'm getting terminology right when I try to search. What shaft/rod pieces would be best for my application? I was on Bob Easton's site and I saw that he could use an adapter but what is the part he screws it to and where can I get one?

Thanks