Hi ..Need some help /ideas jointing Wenge veneer for small panels approx 20" X 20" . So far I have clamped 10 strip then 5 strips between 1" thick white ash boards to keep them flat and together . I have run a router down the edge slowly both directions and I'm getting some tear out on some of the pieces. So the Technic is working on some of it so I be leave the problem is the species. I have looked and rad a few of the posts here of guys using this material but I cant find anything on jointing and yeah its a splinter feast. The material has been sitting for a few years in my basement rolled up in paper and in a plastic bag but not sealed , perhaps its to dry ?
Opinions or ideas from who have some experience with this material would be greatly appreciated . John