I was working on some large panels over the weekend that had an image of a tree and the roots extending out on each side.
logo.png
I split the image in half and engraved each half onto a separate piece of wood. I filled the tree in with black, like I normally would but while engraving the trunk, it would go all the way out and stop at the tip of the root. For each pass, it would travel between the red lines on the image above. This made the job last over an hour for each panel. It seems like it would only travel over the area that needed to be engraved at that time and not worry about the roots until it got that far down. I check for a line or a spot out in the image and didn't see anything that would cause it to travel over all of that white area.
There were also a few vector lines and a vector line to cut the piece out. Would that effect the raster?
Am I missing something in corel or something in the ULS settings?