If you have an angle grinder, a cut-off disk will do the job quickly.
Member
If you have an angle grinder, a cut-off disk will do the job quickly.
_______________________________________
When failure is not an option
Mediocre is assured.
[OP]
Contributor
Thanks Dennis
Contributor
You have to use a hack saw blade with very fine teeth to cut thin plate steel. 24 tpi minimum so you don't rip the teeth off of the blade.
The stock you are cutting cannot go between the teeth in the hack saw blade.
[OP]
Contributor
Michael, my Starrett high carbon steel 8” blade has 24 teeth and it was ruined by the Disston steel saw blade.
Posting Permissions
Reply With Quote