I have a grizzly g0623x slider which has terrible dust collection underneath due to the small outlet of the blade shroud and small flex duct and opening out of the cabinet. (I have great overhead collection with a shark guard). It was suggested that l remove the shroud and enclose the cabinet and connect a 6" outlet to it (which my dust collector can handle having open along with the 4" going to the shark guard). Will this be any different than enclosing a typical table saw cabinet? How do I balance the intake to get all the dust and keep the motor from overheating? There are the typical open slots around the tilt wheel, a louvered panel near the motor, and a 3" hole where the current flex duct exits. It is also open in the bottom, with maybe a 1/4" gap between the cabinet and saw. Thanks for any suggestions!