Thanks for all the ideas and advice everyone. It's been a crazy week and going to be another crazy one. I've got alot of the shop packed so far. I found the original packaging for some of the carbide blades and for others I just taped them into Manila folders (unfortunately the width of only one wasn't enough so I used to for each blade) and stacked them flat in box with cardboard layers in between them. I packed up the table saw, miter saw, circular saw, and sanders. Table saw came off its base easily and the base will actually fit nicely stacked on top of the there was alot of dust in base of the table saw! Vacuumed and then blew it out with compressed air. And the same with the miter saw. Have alot of hand tools left to pack and I just got my pack wrap this evening so that will probably be the task for tomorrow.