Hi group...I am new to the site and was looking for some help or insight on how to create a cutout graphic that would be lasered out into acrylic.
The image shown represents a solid material, acrylic. The red area is what should remain and the white would be the cut outs.
I am not sure if there is a particular font that does this automatically or if I actually have to create cut paths?
The issue with creating cut paths is that it is very time consuming. Keep in mind that a standard Monogram font will not work as it would produce a total drop out
Image one is perfect, image two is not so perfect.
Monogram good.pngMonogram bad.png
Thanks again for you help.
BTW, I am using Illustrator CS6 and Corel X5 and have a few Universal Lasers and a few Gravograph systems.
This is actually a repost as I initially posted the question into the wrong area...rookie mistake.