Hi all,
I hope I'm posting this in the place on the forum.
Does anyone else have this issue, when 'Minimize To Job' is ticked and is working fine on Jobs sent to Trotec Job Control and then for no reason it un-ticks itself? (Print Preferences Corel 7) See image.
Very annoying, because unless you check to see if it's ticked on every job (which takes time) you don't find out until you have sent loads of jobs to Job Control only to find out you need to do them all again.
Both Job Control and Corel 7 are up to date.
I've seen this issue on both Windows 7 and 10 (installed on a clean system).
Regards,
Les
jc.jpg