This is probably second nature to many of you, but it was my first attempt at cross grain dados. These are dados in the sides of a drawer to accept spacers. It’s a long drawer and I wanted a few options so things wouldn’t just slide to the back of the drawer.
Normally I would first saw the two sides and then chisel or router plane it clean. In this case, there was a stop required at the groove for the drawer bottom and I didn’t want to risk sawing through it.
Any shortcuts or suggestions are always welcome.
First up was to scribe the dado sides using a knife and square. I knifed one side, and then used my 1/4” chisel and marked the width for the other side then scribed that as well. I went fairly deep with the cut.
C911A6F3-18D1-4303-9A23-5670F44D8116.jpg
Next I cut small notches at both ends to try to avoid any blow out with the chisel (or later the router plane).
F0FF5C01-6098-4C43-8EC4-2923E09FF3D1.jpg
I then used the chisel to make multiple cuts down the length of the dado and cleaned it out.
9170BE94-601D-4768-9984-F3AD006F26F6.jpg 4B5E8309-1CF9-43FA-AD70-C1F017B62616.jpg
I actually knifed the walls a second time and repeated the chisel cuts and clean out a second time to establish a bit of a deeper wall. I found after the first one, that edge chipping was almost guaranteed unless I took the time to get the walls a bit deeper than the first chisel cut.
Once the second chisel out was complete, I set up my router plane with the 1/4” blade. I also set up a stop for the router plane, so I wouldn’t accidentally blow out the groove from the drawer bottom panel.
28487E87-0A6A-4856-B6FE-8B99BFB4978F.jpg
To be continued....