Ok, so I’m working on this curved table that will have drawers coming out the sides...a take off of a sofa table by Derek Cohen. The way this one works out, is I have a dead space next to the drawer (the dead space is at the back of the table).

So, I could do a drawer front that spans the entire distant...maybe blind dovetail on the left side, and a dado for the right side of the drawer. And it would just be this sort of a drawer front with an extended end.

Or I could do a normal drawer front (blind dovetail both sides), and just glue in a filler in the dead space. I could run a continuation of the drawer front to cover the filler (so it would look somewhat continuous across). I know it’s kind of weird to start with, but looking for any suggestions on how to deal with this unusal situation (I knew all along I was going to have to deal with it, just avoided figuring it out until now).

8FA64FF1-8FB5-456E-A7AE-35E14D28E019.jpg