I think this is only time I have asked a controller / software question. I am using LaserCad 7.36 and I have one file and its the same thing either Imported as a BMP or DFX. One small part of the graphic a Star with Text in the middle when it goes to engrave the top part of the Star the laser head goes so very fast, its almost a blur.

The rest of the project engraves normally??? Yes it may speed up a bit on other small areas but on the top of this Star the laser overruns the edges of the graphic and it looks pretty bad. To make this even worse its a wife project!!!

The JPG I am going to try to UP Load is a Draft version, ignore the rest of the cr@ppy engraving.

StarCropped.jpg