I recently bough an old Speedy from year 2000.
It is in fairly good condition and seem to work but I canīt output anything else from Corel but cutlines.
If I draw a square, make it a red hairline - No problem.
Job control works fins and laser cuts.
If I try to add a black square (engraving) and print it, the file in JC is all corrupted and shows up as a mostly black surface and engrave as such.
I am using printer drivers from a laser I sold years ago that was from 2005 and JC 6.5.4.

°Could it be the printer driver that is wrong, cut lines shows up correctly though!??
°I have tried every possible setting I can think of in Corel X4 with same result!
°The test files provided with JC engraves fine!

I have tried finding other drivers but I canīt find anything, anywhere online.
The laser is a 8003 C25 30W.
Very thankful for suggestions as I canīt think of anything else to try.
Here are some picture with job control in background for reference.
In this specific case the raster work is not all black in JC but still corrupted.

IMG_7961.jpgIMG_7963.jpg