Large trophy base

[David Falkner]

I was given a sketch and asked to build a replacement for this trophy for a General at the base. I think he just wants to refresh the look of the trophy, change some info on plates, etc.

While it is some really pretty Walnut about 90% of it will be covered with engraved plates - ugh! But it's finished and they can do with it what they want, I guess. The base is 17" square, the next level is 15 1/2" square, and the top 2" section on which the cup locates is 10" square. The one critical dimension I was given is that it has to be 21 1/2" tall to the top of the cup. Everything is just setting in place, nothing fastened down in the photos. The missiles were taken from the old trophy and the cup is new.

Original trophy -
001 - Original McAdoo trophy.jpg

New trophy -
002 - McAdoo trophy.jpg

003 - McAdoo trophy.jpg

004 - McAdoo trophy.jpg

Enjoy!
David

[Mark Patoka]

That is very sharp looking. You selected some very nice walnut, even if it will get covered up over the years. It contrasts nicely with the chrome.