Good Afternoon all:

I’m working on a Bar in my basement: I’m moving along, but I ran into a last minute goof that is requiring change:

I built a sturdy cabinet in order to House a kegerator. I got my specs from a few kegerators I was looking at, but I ended up buying one that won’t fit!

So my solution is to cut out the base, and keep the sides/ top, so the I can roll the kegerator right on in.

But, by cutting out the bottom, I’ll have a floppy side panel that’s only secured on the side and top.



My options as I see them, are to

1: cut a piece of plywood to go above the floor and use pocket screws to provide strength (but I’m worried about haveing plywood directly down over tile due to moisture concerns)

2: make a few L brackets and drill them into the tile grout lines?


any advice would help!!!