Hi Phil,
Do you use it indoors (not venting to outside)?.....................My setup is for indoor venting
Does it eliminate all odors?............................................ ....Not all, there is always some smell when lid is open after cutting job. When engraving only it is OK.
Are the filter lifespans/costs reasonable?.............................In my workload pre filter bag lasts couple of months, pleated filter and hepa 6-8 month and carbon pellets ~ 2years.
Is there enough suction to remove smoke from laser bed?.... Suction is OK but not as strong as direct outdoor venting with blower.
Any other thoughts?......................................... ............... If you can venting with blower would be less costly and better option.
Hope this helps.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software