My K3 was as Gene describes, no outrigger and CC fence at the infeed end. To use the F&F jig I bought the fixings (cam adjuster & zero stop pin etc) and put them on the table at the outfeed end because I did not want to disturb the zero/square setting in the original position. As it turns out I bought the out rigger later on and before that I used the CC fence in the new position and some years later have never returned the CC fence to the original factory position. If I were going to do it today I would fashion a simple stop at the outfeed end that could be used to butt the stationery part of the F&F jig against and it would be quickly removeable for ripping longer pieces on the sliding table. The only thing essential to the stop is that it is square to the table so some sort method of setting the it to zero quickly against a stop would be essential.
Last edited by Chris Parks; 09-15-2017 at 7:59 PM.
Chris
Everything I like is either illegal, immoral or fattening