I'm working at making my own wooden nickels for an upcoming event, and I think I've figured out how to do both sides nicely, but now I've a printer issue that has suddenly and inexplicably cropped up.

In setting up the page in Corel X5, I have used my top left corner as my starting point for X,Y coordinates, and built up the artwork, etc., from them. However, when I go to print the page, the printer setup dialogue box has the selected work pushed in and down from 0,0. I manually reset the table parameters (406.8, 308.4) each time I go in to set the raster and vector speeds and powers (always have) so that isn't the issue. I've also got the "place page at Top Left corner" ticked in that dialogue box, so I'm at a loss as to what the issue is. As I say, until this current "print" run, and in all my other saved works, it goes where it should, but today for some reason, no joy. The only other difference is that this time I set the table size from 16x12 to 12x6 because of the size of the wood I'm using.

It's almost as though both the printer and the lazer are somehow offset from 0,0 on the table platform.

Any suggestions would be appreciated. Thanks. Paul